Jaw crusher parts cleaning method

Article source：

In daily use, Jaw crusher will inevitably stained with oil and impurities, these oil and impurities normally provided by unsaponifiable oil and dust, such as the formation of impurities . These oil impurities is not the same , so to select the appropriate cleaning solution ( organic solvents, alkaline solutions and chemical cleaning liquid, etc. ) . Then cleaning work , jaw crusher parts cleaning methods can be divided into two ( manual cleaning and mechanical cleaning ) .
Manual cleaning

1 scrub. The Jaw crusher  parts into with diesel , kerosene , or other cleaning fluid container with cotton scrub or scrub with a brush . This method is simple , simple equipment , but the efficiency is low, suitable for single piece and small batch of small parts . Under normal circumstances should not use gasoline , because there is fat soluble , it will harm human health and could easily lead to a fire.

2 spray . To a certain pressure and temperature cleaning liquid to a surface of the part to remove oil . Hongxing Heavy cleaning effect that this method , high production efficiency , but the equipment is complex and less complex shapes suitable for cleaning the surface with serious grease parts.
Mechanical cleaning

1 boiling water. Good solution and the configuration of parts to be cleaned with steel welded together into the appropriate size cleaning pool with heated pool next to the stove to 80 ~ 90 ℃, washed 3 ~ 5min to cook .

2 Vibration cleaning . Will be cleaned jaw crusher parts on a vibrating washing machine washing basket or clean the shelves , and immersed in the cleaning solution through the washing machine vibration to simulate artificial drift movements and rinse the chemical action of the cleaning solution to remove oil.

3 ultrasonic cleaning . By the chemical action of the cleaning liquid into the cleaning solution with ultrasonic vibration together to remove the oil.