Questions about the Rotary kiln reducer

Article source：yufeng

According to the real thing in practice is that the current problem is the Rotary kiln gear wrapped around an important component of the overall process.On faulty gearbox problem may be necessary to stop the entire production line.In this issue we will address the relevant aspects of the reducer. According to our current design algorithms Rotary kiln reducer manufacturing situation, recommend using a Rotary kiln (JB 1130-70) and part of the draft standard ZS and ZL three two-stage gear reducer. Given the low rate of Rotary kiln load when operating the motor, speed reducer should choose to calculate the maximum torque at start of peak load, the operator reducer peak load carrying capacity, taking into account the non-ferrous metallurgy Rotary kiln factory-made spare parts The material may be lower than the original design and quality requirements, should be above the carrying capacity of the two series reducer standard 10% reduction given access.